Instruction manual

ENGLISH | 7
visible at the bottom right of the LCD screen. The bottom right of the screen will also
show the memory available on the SD card. When imaging, the images are saved on
the SD card and not in the internal storage memory. Do not pull and insert the SD
Card quickly or errors may occur.
NOTE: Inserting or removing an SD card while the LCD is on, may cause the LCD to shut down and/or could
damage the SD card.
E. TRANSFERRING IMAGES TO YOUR COMPUTER — To transfer images to a PC or
MAC, you need to have a free USB port and have an imaging program to use for
snapshots and/or videos.
NOTE: Do not disconnect the USB cable while transferring images or damage may occur.
You can transfer images from the internal storage memory to your PC by using the
supplied Mini USB Cable. The small plug end of the cable plugs into the USB Port
(12) on the back of the microscope, and the large plug end of the cable plugs into
your computer. If the connections are proper, you will see (on your microscope screen)
“MSDC” or similar data/icon. Your computer will automatically recognize the new
hardware. Next, you will choose which program on your computer you want to transfer
the images to.
If you used an SD card to store your images, you can transfer them to your PC using the
same method mentioned above. You can also remove the SD card and insert it into your
computer (if there is an SD card slot available) to transfer the images. Either way, your
PC will ask you to choose which program you would like to transfer the images to.
CARE, MAINTENANCE AND WARRANTY
Your microscope is a precision optical instrument and should be treated with care at all
times. Follow these care and maintenance suggestions and your microscope will need
very little maintenance throughout its lifetime.
• Storethemicroscopeinadryandcleanplaceinsidethepouchincluded.
• Beverycarefulifusingyourmicroscopeindirectsunlighttopreventdamagetothe
microscope or your eyes.
• NeverpointthemicroscopetowardstheSun,orthecameramaybecomedamaged
and cease to operate.
• Cleantheoutsidesurfaceswithamoistcloth.
• Blowoffdustwithacamel’shairbrushorairblowerfromtheopticalsurfaces.
• Neverdisassembleorcleaninternalopticalsurfaces.Thisshouldbedoneby
qualified technicians at the factory or other authorized repair facilities.
• Donotdisassembleortakeapartthemicroscopeordamagecanoccur.
• Whenhandlingglassspecimenslides,usecareastheedgescanbesharp.
• Ifthescreenfreezesupforanyreason,poweroffandstartagainorremoveand
replace the batteries.