Instruction manual

4 | ENGLISH
SPECIFICATIONS
LCD Screen
2.4 inch /60 mm TFT
320 x 240 resolution
Sensor Resolution /
Interpolation
3MP CMOS Sensor 2048x1536 /
digital up to 12MP
Optical Power (Magnification)
1 to 3.7x and 54x with
digital zoom up to 216x
Illumination 6 White LEDs
Digital Zoom 4x
Internal Storage
128MB Flash Memory
(3MP – est. 250 Snapshots & 5min. Video)
SD Cards Supported Up to 16GB
Field of View 26 mm @ 2x, 14 mm @ 3.7x, 2.5 mm @ 54x
USB Cable 2.0
Image Format Snapshots: JPG — Video: AVI
Power Requirements 2AA Batteries (user supplied) 0.75W
Weight / Dimensions
6.6 oz (187 g) /
3.8” x 2.5” x 4.2“ (96 x 63 x 107mm)
Operating Temperature 0°C to 40°C (32° F to 104° F)
GETTING STARTED
BATTERY INSTALLATION
To use your microscope install 2AA batteries which provides the power to operate it
indoors or outdoors. Slide the battery cover on the bottom of the microscope (5) to
open, and insert the batteries according to the battery polarity as shown. After the
batteries are installed, close the battery cover. Battery condition will be shown in the top
left of the LCD in viewing and video modes, and “Low Battery Condition” will be shown
in red on the screen to notify you.
NOTE: When not using the microscope, you will want to turn it off to preserve battery life. Typical battery life is 1.5 hours
using 3 LEDs and 0.75 hours using all 6 LEDs. For most applications, 3 LEDs are all that are needed for
proper illumination.
Also, if the microscope will not be used for a few weeks or more, remove the batteries.