Specifications

shows the G8 mount with DEC motor removed. Note the

portion of the of the coupler still attached to the worm shaft.

Shaft Coupler

Step 5:

Refer to Fig 4 for the following. The plastic coupler

interface is symmetrical and either side can be installed

on the motor/gearbox. Install coupler (removed at step

2) on the new DEC Motor/Gearbox

Note: the DEC Motor/Gear Box is the one with the long

cab/e.

Make sure the setscrews line up with the flats on motor shaft. The coupler should be

pressed on the shaft as far as it will go. Tighten both setscrews

Coupler

Interface

Shown

Slid

partially

off

Fig

Step 6:

If the Plastic piece came out with the motor make sure it is

centered on the coupler.

Step 7:

Refer to Fig 5, Insert 2ea #6-32 x 1 % long Allen head screws

through the gearbox from the motor side.

. Mounting Screws

Rotate the shaft to align the slot in the plastic coupler with rod on the Fig

coupler section on the mount. Push the motor/gearbox on the mount and tighten the 2

screws using the Allen wrench provided.

Fig 6. Shows the DEC motor/gearbox attached to the

mount. The worm cover has been removed to show how

the coupler should look.

i ~

Caution: Do not remove the worm cover as this

could expose the gears to possible damage.

RA Motor Installation

Fig

Step 8:

Repeat steps 2 through 7 except for RA Motor. Fig 7 shows the RA motor properly

attached to the G 11 mount.

Fig