Specifications

slid on the dec plate. Slide the gearbox toward the worm

until the output gear on the gearbox and the gear on the

worm shaft engage. You may have to turn the knob on the

worm shaft for them to line up. There should be a small

amount of backlash so the gears do not bind. Tighten up

both screws. To check the backlash turn the knob on the

worm shaft back and forth. There should be a perceptible

movement in the gear on the worm shaft before the gear on

the gearbox starts to rotate.

RA Motor Installation

Fig 13

Step 4:

Repeat steps 2 through 7 except for RA Motor. Fig

14 shows both motors properly attached to the CI-

700 mount.

Digital Controller Installation

Step 5:

With reference to Fig 15, using a No.2 Phillips head

Fig 14

screwdriver remove the 4

screws (in the corners) that

hold the CI

700

Drive

Controller in its enclosure. Using the screws

just removed, attach the Ramona Controller

mounting bracket as shown in Fig 16. With

reference to Fig 17 install the

9()n

digital

controller on the mounting bracket with the 2

knobs supplied. Adjust the angle of the

controller as desired. Tighten both of the

hand screws so that the controller is

snugged tightly to the mounting bracket.

Remove

these screws

Fig 15