Installation guide

Celestix HOTPin Appliance Installation Guide Page | 82
LGV
The LGV instructions below require direct access to the Celestix appliance.
To create an LGV:
Notes:
 You will need to shut down your appliance and then start it
again to access the system recovery process.
 It may help to read through all of the instructions before starting
the procedure.
1. Shutdown the appliance.
2. The front panel display shows the System Off message after shutdown
has completed.
3. Press the Jog Dial to start the appliance; the front panel display shows
System On, and the system beeps for system startup.
4. Next the front panel display shows the System Ready message, and
the system will beep again. On this second beep, turn the Jog Dial
clockwise two full rotations to initiate the recovery system.
Note: Timing when you turn the Jog Dial is more important than
how long you turn it. Two full rotations should be adequate to
start the recovery system process.
5. The front panel display will show Celestix Appliance Installer when the
recovery process launches. Menu options will display when the recovery
system has loaded.
6. Turn the Jog Dial to scroll to the option Create Last Good Version <<
and press to select.
7. Confirm the operation when prompted.
The Saving System Image screen will show a progress indicator and an
estimated time to completion for the image copy process.
After the image has been created, the system will reboot. DO NOT ACCESS OR
TURN OFF THE APPLIANCE DURING THIS PROCESS.
The appliance will shut down when the LGV process is complete.
Now that you have completed the configuration steps and system image
creation, you should check for appliance software updates. See the next section
for information.