Installation guide

Celestix HOTPin Appliance Installation Guide Page | 20
Configure Initial Access
The appliance can be deployed in a network that does not use DHCP, but it is
generally easier to start setup with a DHCP-assigned IP address for your internal
network (LAN0) adapter. If you need to assign IP addresses to any adapters
manually, you will use the Jog Dial/front panel as explained in the next section,
Configure IP Address without DHCP.
Configure IP Address without DHCP
Skip this section if your network uses DHCP. Instead, start with the section
Access the Web User Interface.
You will need the IP address for your internal network (LAN) adapter to access
the appliance administration website, or web UI, which you will use to complete
the setup for your appliance. If you can’t use DHCP, this topic explains how to
do it manually through front panel controls. If you enter the internal network
adapter (LAN) IP address through the front panel, you will not need to do it in
the later section, Quick Setup Steps : Interfaces.
To change the internal network IP address:
Note: You will only need to follow this step if you do not have DHCP
configured for your network.
1. Press the Jog Dial and scroll to > Configure Network <.
2. Press the Jog Dial again to select.
3. If necessary, press the Jog Dial and scroll to and select LAN. The
display should show [ LAN0 ].
4. Scroll to and select [ Next ] to continue.
5. Scroll to and select [ Static IP ].
6. Enter the IP address:
a. Press the Jog Dial to edit the first octet of the IP address.
b. Turn the dial to change the number.
c. Press the Jog Dial again to complete entry.
d. Repeat for the remaining octets.
7. Scroll to and select [ Next ] to continue.
8. Enter a Netmask if needed.
9. Scroll to and select [ Proceed to Configure ] to save your entry. You
will see the Configure Network screen when the process has
completed.
10. Scroll to > Back < and select to return the front panel display to idle
mode.