Installation guide

Celestix HOTPin Appliance Installation Guide Page | 14
Network Information Worksheet (example)
Property
Network Information
(example)
Explanation
Computer Name
The appliance must be assigned a computer name.
The computer name must be 15 alphanumeric
characters or less.
This information is needed in:
Quick Setup : Server Name
Administrator Password
[Celest1x] (default)
The administrator password is the password used
to log on to the appliance. Define the administrator
password during setup using at least six characters
and at least three of these four categories:
 Uppercase letters
 Lowercase letters
 Number
 Non-alphanumeric characters (for example, !,
$, #, %)
Note: The default user name is “administrator” and
the default password is “[Celest1x]” (case sensitive,
brackets included). The system administrator
should change the default password in the Quick
Setup steps.
This information is needed in:
Quick Setup : Administrator Password
Workgroup or
Domain name
Record the name of the Workgroup or Domain that
will be joined during setup.
This information is needed in:
Quick Setup : Server Membership
Network Adapters
IP Address:
Subnet Mask:
Default Gateway:
Primary/Secondary DNS
Server(s):
Static Routes:
Network Address:
Gateway Address:
This information is needed in:
Quick Setup : Interfaces
Active Directory Server
IP Address:
Hostname:
This information may be needed for application
setup.
Application Server
IP Address:
Hostname:
This information may be needed for application
setup.
Illustration 3 - Network Planning Form Example
Rack Your Appliance
Your Celestix appliance is a 1U or 2U device that should be attached to a
standard 19-inch equipment rack as follows:
Note: If your appliance shipped with slides instead of brackets, see
the instructions included in the slide packaging for the rack
mounting procedure.