System information

17 | P a g e Celestix DAX Series Quick Start Guide
for your appliance. Initially, this IP address is normally assigned through DHCP by
default. If you cannot use DHCP for the initial IP address setting, the Jog Dial and
front panel display can be used to enter a static IP address for the LAN adapter. If you
enter the internal network adapter IP address through the front panel, you will not
need to do it in the later section, Quick Setup Steps : Interfaces.
To change the internal network IP address:
Note: You will only need to follow this step if you do not have DHCP
configured for your network.
1. Press the Jog Dial and scroll to > Configure Network <.
2. Press the Jog Dial again to select.
3. If necessary, press the Jog Dial and to scroll and select LAN. The display
should show [ LAN ].
4. Scroll to and select [ Next ] to continue.
5. Scroll to and select [ Static IP ].
6. Enter the IP address:
a. Press the Jog Dial to edit the first octet of the IP address.
b. Turn the dial to change the number.
c. Press the Jog Dial again to complete entry.
d. Repeat for the remaining octets.
7. Scroll to and select [ Next ] to continue.
8. Enter a Netmask if needed.
9. Scroll to and select [ Proceed to Configure ] to save your entry. You will see
the Configure Network screen when the process has completed.
10. Scroll to > Back < and select to return the front panel display to idle mode.
Web User Interface Access
You are now ready to configure your appliance using the web UI. From a client
computer on your network, default access to the appliance web UI is through Internet
Explorer at https://ServerName|IP address:8098.
For example, if your server IP address is 192.168.30.4, the web UI URL would be
https://192.168.30.4:8098