System information

Celestix DAX Series Quick Start Guide Page | 16
ranges, and/or subnets from which you will access the appliance. Examples of remote
management include RDP connections and the administration web UI.
Note: The Remote Management front panel control feature will add the IP address
information you enter to the TMG Remote Management Computers Computer
Set.
To add remote management IP address sets:
1. Press the Jog Dial and scroll to > Remote Management <.
2. Press the Jog Dial again to select.
3. At Operation, make sure [ Add ] is selected, the scroll to [ Next ] and press
the Jog Dial.
4. At Add New Rule Element, press the Jog Dial to scroll to and select from the
following options:
 Computer – enter the terminal IP address.
 Range – indicate a contiguous range of IP addresses.
 Subnets – enter a subnet address and mask.
Press Jog Dial to enter selection.
5. Scroll to and select [ Next ].
6. Enter IP information with the Jog Dial, one octet at a time. For example:
a. Press to edit > 000 <.
b. Turn to enter number > 192 <.
c. Press again to complete [ 192 ].
d. Scroll to and select [ Next ].
7. Confirm your entry when prompted to proceed. You will see the Remote
Management screen when the process has completed.
8. Scroll to and select > Back < to return the front panel display to idle mode.
Repeat the steps above to add multiple entries. You can configure a mix of
computers, subnets and ranges.
Configure IP Address without DHCP
Skip this section if your network uses DHCP.
You will need the IP address for your internal network (LAN) adapter to access the
appliance administration website, or web UI, which you will use to complete the setup