User's Manual

Page | 14

After gaining access to the circuit board and the fuse, gently remove the fuse from its socket

using a needle-nose plier. Replace with identically rated fuse only and ensure the new fuse is

installed securely.

For re-assembly, simply reverse all of the steps above:

1. Instal the upper receiver

2. Install the inner barrel.

3. Install the charging handle

4. Ensure the sector gear is aligned correctly

5. Install the cylinder unit (note the alignment notch on the unit, and make sure the cylinder

is inserted all the way)

6. Close the upper receiver.

7. Move rear receiver pin back to its position.

CTW – Celcius Training Weapon

Made in Hong Kong