Owner`s manual

Controls Setup & Commissioning
P ROFILE S ERIES O WNER ’ S M ANUAL
TEK600 S ERIES C ONTROL
Page 16
Setting the Pre-cool.
(4 hour light on and Auto light flashing).
1. To disable the Pre-cool feature rotate the dial fully to the minimum position and the auto
light will flash once every two seconds.
2. To activate the Pre-cool feature rotate the dial fully to the maximum position and the auto
light will flash twice every two seconds.
3. Press the FAN button once to select the desired mode. (The fanlight will flash three
times to confirm the setting).
4. Press the AUTO button to go to the next setting or press the timer button to cancel.
Setting the Dump Interval Cycles
(8 hour light on and the Auto light flashing).
1. To disable the dumping cycle feature rotate the dial fully to the minimum speed position
and the auto light will flash once every two seconds.
2. To activate the one hourly dumping cycle, rotate the dial anti-clockwise until the auto
light flashes twice every two seconds.
3. To activate the two hourly dumping cycle, rotate the dial anti-clockwise until the auto light
flashes three times every two seconds.
4. To activate the four hourly dumping cycle, rotate the dial anti-clockwise until the auto
light flashes four times every two seconds.
5. To activate the eight hourly dumping cycle, rotate the dial anti-clockwise until the auto
light flashes five times every two seconds.
6. To activate the twelve hourly dumping cycle, rotate the dial anti-clockwise until the auto
light flashes six times every two seconds.
7. To activate the twenty four hourly dumping cycle, rotate the dial anti-clockwise until the
auto light flashes seven times every two seconds.
8. Press the FAN button once to select the desired mode. (The fanlight will flash three
times to confirm the setting).
9. Press the AUTO button to go to the next setting or press the TIMER button to cancel.
Setting the Pre-fill (2 + 4 hour light on and the Auto light flashing).
1. To disable the pre-fill feature rotate the dial fully to the minimum speed position and the
auto light will flash once every two seconds.
2. To activate the Pre-fill feature, rotate the dial fully to the maximum position and the auto
light will flash twice every two seconds.
3. Press the FAN button once to select the desired mode. (The fanlight will flash three
times to confirm the setting).
4. Press the TIMER button to complete the programming and to resume to normal
operation