User manual

Script Name What it does
ZicDoodleCtrl.py Uses the potenometers on the EVB2 board to control an LCD
display on an EVB1 board. This script used funcons
deprecated as of release 2.4.
ZicDoodlePad.py Demonstrates the lcdPlot() built-in on a ZIC2410-LCD
demonstraon board. This script (along with that funcon) is
deprecated.
zicHardTime.py How to reference the clock on the nodes based on the ZIC2410
chips. (Imported automacally by hardTime.py)
ZicLinkQuality.py A ZIC2410 counterpart to the original LinkQualityRanger.py
ZicMcastCtr.py A ZIC2410 counterpart to the original MCastCounter.py script
ZicMonitor.py Reads some ADCs on a CEL EVB1 Evaluaon Board, plots the
data in real-me on the EVB1 LCD display. This script used
funcons deprecated as of release 2.4.
Scripts specific to the ATMEL ATmega128RFA1 Platforms
These scripts are meant to be run on the corresponding ATMEL hardware plaorm. See also the scripts specific
to the RF200, which is based on the ATmega128RFA1 chip.
Demonstraons wrien for the ATMEL STK600 board will also run on a Dresden “RCB” board, but then any
references to “LED color” are wrong. (All the LEDs are red on the “RCB” board, compared to the
red/yellow/green set on the STK600.)
Script Name What it does
atFlasher.py Demonstrates light flashing on a Dresden RCB test board
with an ATmega128RFA1 node. This sample script is
deprecated and may not be included in future releases.
atMcast.py Demonstrates parcipaon of an Atmega128RFA1 on a
Dresden RCB test board in a group of nodes running
McastCounter.py. This sample script is deprecated and
may not be included in future releases.
pinWakeupATmega128RFA1.py Pin Wakeup funconality specifically for the
ATmega128RFA1-based modules. (imported
automacally by pinWakeup.py)
STK600.py Defines and LED control rounes for the STK600 board.
This is imported by STK600demo.py.
SNAP® Network Operang System 55