User guide

ZIC2410 Getting Started Guide
Rev E Document No. 0005-05-08-11-001 Page 7 of 22
3 INSTALLING THE USB TO COM PORT DRIVER
In order to interface a PC to the evaluation boards or the ZIC2410USB-WNA, a driver file
must be installed onto the PC, allowing it to utilize the USB port. The USB to RS-232 driver
installation file can be found on the CD in the
\ZIC2410\Tools\Others\CP210X_DRIVER\ directory.
3.1 Installing the Drivers
The following is the procedure to decompress the drivers:
1. Double-click on the “CP210x_VCPInstaller.exe” executable, if prompted by an Open
File – Security Warning dialog box, click the Run button.
2. When the Silicon Laboratories CP210x USB to UART Bridge Driver Installer dialog is
displayed, accept the default installation location and click the Install button.
Figure 1 – Silicon Labs CP210X Driver Installation
3. Once the installation has completed successfully, click the OK button.
Figure 2 - Silicon Labs CP210X Driver Installation Successful
The CP210x Driver installation is now complete.