User guide

ZIC2410 Getting Started Guide
Rev E Document No. 0005-05-08-11-001 Page 16 of 22
5.2.2 ZICM2410-EVB3 Default Settings
For normal operation of the evaluation board, the jumpers and DIP switches should be
placed in the following locations:
Connector Settings
J9 1-2
J200 Open
U203 1: ON, 2: ON, 3: ON, 4: ON, 5: ON, 6: ON, 7: ON, 8: ON, 9: ON, 10: ON
U204 1: ON, 2: ON, 3: ON, 4: ON, 5: ON, 6: ON, 7: ON, 8: ON, 9: ON, 10: ON
U205 1: ON, 2: ON, 3: ON, 4: ON, 5: ON, 6: ON, 7: ON, 8: ON, 9: ON, 10: ON
5.3 ZIC2410USB-WNA WIRELESS NETWORK ANALYZER
The MeshConnect ISP / WNA USB dongle contains 3 status LEDs (Amber, Red and White)
and three user-accessible switches (two push-button and one slider). Table 6 and Table 7
detail the various statuses indicated by the LEDs and the functions of the various switches.
Figure 13 details the locations of the various switches and LEDs of the MeshConnect ISP /
WNA.
LABEL COLOR DESCRIPTION
Active Amber
Indicates whether the MeshConnect ISP / WNA received a
valid packet (SMAC or MAC) when operating in WNA-
mode.
Power Red
Indicates whether the MeshConnect ISP / WNA is
powered. When the RED LED is illuminated, sufficient
power has been applied, when off the ISP / WNA is not
powered.
ISP White
Indicates the MeshConnect ISP / WNA operating mode,
when the WHITE LED is illuminated the ISP / WNA is in
ISP-mode (the MS2 / ISP output of the dongle is ‘1’), when
off the ISP / WNA is in WNA-mode (the MS2 / ISP output
of the dongle is ‘0’).
Table 6: Status LED Descriptions
NAME /
LABEL
TYPE DESCRIPTION
(Remote)
Reset
Push
Button
Toggles the MeshConnect ISP / WNA Remote RESET
output when the MeshConnect ISP / WNA is in ISP-mode.
When pressed, the target device is placed in RESET.
(Remote)
ISP
Push
Button
Toggles the MeshConnect ISP / WNA operating mode,
when the WHITE LED is illuminated the ISP / WNA is in
ISP-mode, when off the ISP / WNA is in WNA-mode.
WNA
Reset
SPST
Slider
Resets the MeshConnect ISP / WNA USB dongle.
Table 7: Switch Descriptions