User manual

7. FACTORY DEFAULT

Parameter Value

User name root

Password dbps

Operating mode RealPort

Bout rate[bits/sec] 9600

Number of data bits 8

Parity Control no

Number of stop bits 1

Flow Control no

8. PROBLEMS

Problem Solution

I forgot the password

Restoring Default Settings according to steps below:

1. Disconnect the power of the converter,

2. Remove the cover of ETHERNET connector,

3. Press RESET “RST” and holding the button, connect the power

of the converter,

4. Release the button after 20 sec. when the converter will start

with default settings.

Restoring Default Settings deletes existing configuration and the

proper configuration should be loaded to the converter form the

backup.

I changed the configuration and the converter isn't functioning.

1. Enter in the Internet browser http://converter-ip-address,

2. Select the menu [Factory Default Settings] press [Restore].

9. VERSIONS

ADA-13021 - - -

Order example:

Product Symbol: ADA-13021-1-2-2

1 – basic version of electronic,

2 – 12VDC / 0-20mA (TTY) Current Loop type,

2 – 1kV= galvanic isolation.

Electronic versions:

Basic

Current Loop type:

24VDC / 20mA – active/passive transmitter/receiver

12VDC / 20mA (TTY) - active/passive

transmitter/receiver. Standard version

Galvanic isolation:

1kV DC

3kV DC

ADA-13021