User manual

Fig. 18. Selection serial port profile web
5.2.2.1.1. REALPORT (VIRTUAL PORT ) CONFIGURATION
Choosing RealPort (Virtual Port, Fig. 18) is configured the serial port of ADA-13021, for communication with virtual port COM of
computer. Press [Apply] for save. After installation driver (RealPort) of virtual port COM (see chapter 6) in operating system, data
sending by application to this port are transferred through WLAN/WAN to ADA-13021 converter and are present on his serial port. The
driver RealPort installation is presented in chapter 6. Normally RealPort service allows for one connection through WLAN/WAN,
between computer and server port.
Connection from other computers to the converter will be not taken, what will cause the error message.
5.2.2.1.2. TCP SOCKETS CONFIGURATION
Choosing TCP Sockets is configured the serial port of ADA-13021, for direct communication with PC or other network device by the
use of TCP socked. Data sending by application/device to TCP socked are transferred through network to ADA-13021 converter and
are present on his serial port. To save selected configuration, press the button [Apply].
5.2.2.1.2.1. TCP SERVER & CLIENT CONFIGURATION
After saving the profile in section TCP Server Settings, set parameters of TCP server. As on the picture below set correct services
and proper ports on which are working. Additionally there is the possibility of selection Enable TCP Keep Alive – connection will be
kept, even if the data is not transmitted over the network.
Fig. 19. Example configuration of TCP server
16
ADA-13021