Installation Guide

First, connect your GO X to power, and download the Wave app to make sure the GO X is

boosting your carrier. You won't need any antennas in this step.

Note: only one device can connect to the Cel-Fi GO X via

Bluetooth at a time. But don’t worry – every device in the

building will see better cell signal, the Wave app is only

used to change settings and monitor the GO X.

1 Plug your Go X into a power outlet to power it on,

don't connect any antennas just yet.

2 Download the Wave app by visiting waveform.com/

waveapp.

3 Open the app while keeping your phone within 4

feet of the GO X to start pairing. This may take a few

minutes. The app will say “searching,” “syncing data,” and

 nally “gathering data.”

Wave App and Carrier Selection

Your GO X is preprogrammed to boost Verizon.

If you're with a different carrier, change it under "Operator" in the “Settings” tab. This takes a

few minutes - don’t turn off your booster or move your phone away during the process.

Note for AT&T customers: if there is 4G LTE signal outdoors, choose “AT&T LTE Preferred”.

This will ensure that the GO X boosts as many LTE bands as possible, instead of boosting 3G.

Troubleshooting Wave App Pairing:

• If the Wave app is unable to connect to your device,  rst try force-closing the app.

• In Android, this is done by going to your phone’s Settings, choosing the “Apps”

option,  nding the Wave app, and then choosing the “Force Stop” option.

• For iOS, you can read here about how to force-close apps:

waveform.com/fcios

• If force-closing the app doesn’t help, restart your phone and power cycle the GO X

by unplugging the power adapter.