Installation Guide

Getting the parts set up

Refer to the diagram to the right as needed

1. Connect the two SMA Pigtail cable adapters to the Cel-Fi GO X ampli er.

2. Note the two icons by the Cel-Fi GO X’s two SMA antenna ports:

This port should be plugged into the indoor antenna(s).

This port should be connected to the outdoor antenna.

3. Connect the RS400 cables to the SMA pigtail adapters and hand-tighten them.

4. If you have a kit with 2x, 3x, or 4x indoor antennas, connect your splitter to the indoor

antenna end of the booster using the 1 ft jumper.

5. Connect the 30 ft cable(s) and panel/dome indoor antenna(s) to your splitter or directly

to the indoor antenna port of the Cel-Fi Go X and hand-tighten the connectors.

6. Connect the Outdoor Antenna to the 5 ft RS200 cable, Lightning Surge Protector, and

RS400 cable. Instructions on grounding are in the next section of the manual.

7. Connect the Cel-Fi Go X power supply and plug it into the booster.

Assembling the J-Mount and Antenna

The photo to the right shows how the Log Periodic Antenna should

be secured to the included Antenna Mount.

If you’d like more detailed instructions on how to install the L-bracket

to the antenna mount, you can  nd that online at waveform.com/

polemount-instructions

If you got the kit with the Grid Parabolic outdoor antenna, refer to

the included guide for instrctions to assemble that. You can also  nd

that online at

waveform.com/griddy-guide

Assembling Your Kit