Installation Guide

EZ-On Wall Angle Covers install along the edge of your ceiling, everywhere your grid touches a wall. They

are cut to fit perimeter portions of ceiling grid, and have an over-lip along their length which holds them firmly

in place.

To install, simply slide them onto the portion of your grid running along the perimeter of your ceiling.

If you have a 2 ft. x 2 ft. ceiling layout, you’ll need one cover for each section. If you have a 2 ft. x 4 ft.

ceiling layout, you’ll need three covers (two and a little bit extra) for each section. In the case of a 2 ft. x 4 ft.

layout, there are no hard-fast rules, any combination of wall angle cover lengths you think looks best will

work.

If your ceiling has any outside corners, your wall angle covers can simply be trimmed to fit and slid into

place. For inside corners, if the corner isn’t riveted, just trim to fit and let the covers overlap. If the corner is

riveted, trim off a section of the over-lip to create a tab that will cover the exposed grid section in the very

corner.

When your wall angle covers are all installed, your perimeter grid will still not be completely covered; there

will be a gap where your ceiling grid mains connect to your wall angle. These gaps will be covered by the

tabs on your main/feature grid covers.

EZ-On Wall Angle Covers

Face

Over-Lip

PAGE 1
EZ-On Wall Angle Covers Over-Lip Face EZ-On Wall Angle Covers install along the edge of your ceiling, everywhere your grid touches a wall. They are cut to fit perimeter portions of ceiling grid, and have an over-lip along their length which holds them firmly in place. To install, simply slide them onto the portion of your grid running along the perimeter of your ceiling. If you have a 2 ft. x 2 ft. ceiling layout, you’ll need one cover for each section. If you have a 2 ft. x 4 ft.
PAGE 2
EZ-On Main Covers Up-Turn Over-Lip Face EZ-On Main Covers install on all your main beams and cross T’s. They are cut to fit 2 ft. lengths of ceiling grid, have a tab at one end, and an over-lip and up-turn edge which allow them to slip on and click into place. To install, simply slide them onto your ceiling mains or T’s and click them into place. Once installed the tabs cover the exposed sections of grid at intersections and the gaps between wall angle covers. If you have a 2 ft. x 4 ft.