Installation Guide

Hardware
C: Place Roof Spacer Assembly from Step 20, on top of the Small Roof Assembly, ush to the edge as shown in
g. 21.5.
D: Measure 1/2” in from the edge and 7” up from the bottom of each (211) Small Roof Panel and mark. Follow
with 11” up from the rst mark and then 11” up from the second mark. Pre-drill with a 1/8” drill bit at all 6 marks.
(g. 21.6 and 21.7)
E: Attach Roof Spacer Assembly to Small Roof Assembly with 3 (S3) #8 x 2-1/2” Wood Screws per side. (g.
21.6 and 21.7)
6 x #8 x 2-1/2” Wood Screw
S3
Step 21: Small and Large Roof Assemblies
Part 3
Fig. 21.5
211
Fig. 21.6
Fig. 21.7
S3
211
7”
11” 11”
1/2” Screw to
Panel End
Roof Spacer Assembly
Roof Spacer Assembly
Flush
x 3 per side
84 [e-mail]