Installation Guide

Warning! To prevent tipping and avoid potential
injury,stakesmustbedriven13”intoground.Diggingor
drivingstakescanbedangerousifyoudonotcheckrst
forunder-groundwiring,cablesorgaslines.
A: In the 4 places shown in g. 13.1 drive the Rebar Ground Stakes 13” into the ground against (063) Front
Ground, (065) Back Ground and both (111) Diagonals. Be careful not to hit the washer while hammering stakes
into the ground as this could cause the washer to break off.
B: Attach ground stakes to (063) Front Ground, (065) Back Ground and both (111) Diagonals using 1 (S7) #12 x 2”
Pan Screw per ground stake as shown in g. 13.2 and 13.3.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
Step 13: Install Fort Ground Stakes
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
Hardware
4 x #12 x 2” Pan Screw
S7
4 x Rebar Ground Stake
Other Parts
Fig. 13.3
Fig. 13.1
Fig. 13.2
SEE FRONT COVER FOR SAFETY CLEARANCE
Front
and
063
S7
S7
13”
In Ground
065
111
Ground Stake
Ground Stake
13”
In Ground
110
111
111
Inside View
86”
109”
47”
101”
64 [e-mail]