Installation Guide

1 x Left Access Rail FSC 2 x 4 x 62-7/8”
1 x Right Access Rail FSC 2 x 4 x 62-7/8”
4 x Ladder Tread FSC 5/4 x 4 x 13-3/4”
022
021
020
Fig. 2.1
Wood Parts Hardware
Step 2: Access Ladder / Rockwall Assembly
Part 1
A: Place (020) Left Access Rail on left hand side of 4 (022) Ladder Treads and (021) Right Access Rail on right
hand side with the grooves facing in. (g. 2.1)
B: Fit each (022) Ladder Tread into grooves on both (020) and (021) Access Rails, make sure the top edge of the
treads are ush to the front of the Access rails. (g. 2.1 and 2.2)
C: Pre-drill pilot holes with a 1/8” drill bit and attach Rails and Ladder Treads together using 4 (S3) #8 x 2-1/2”
Wood Screws per tread. (g. 2.1)
Other Parts
2 x Swing Bracket
16 x #8 x 2-1/2” Wood Screw
2 x 5/16 x 1-3/8” Wafer Bolt
(5/16”atwasher,5/16”t-nut)
WB2
S3
Fig. 2.2
Fig. 2.3
020
021
022
Swing
Bracket
End View
WB2
5/16” Flat
Washer
5/16” T-Nut
Flush to
edges
021
D: Attach Swing Brackets to the inside top of (020)
and (021) Access Rails at angled edge using 1 (WB2)
5/16 x 1-3/8” Wafer Bolt (with at washer and t-nut)
per bracket. Edge of Swing Bracket is ush with edge
of access rails. (g. 2.1 and 2.3)
Left Side
Right Side
Top of Ladder View
S3
S3
022
25 support@cedarsummitplay.com