Installation Guide

A: Loosely attach 1 (011) Box End to 2 (010) Box Legs using 2 (WB2) 5/16 x 1-3/8” Wafer Bolts (with at washer
and t-nut), as shown in g. 1.1 and 1.2. Make sure (011) Box End is level and ush with ends of each (010) Box
Leg and the pilot holes in each (010) Box Leg are on the outside.
B: Loosely attach 1 (012) Box Ground to the (010) Box Legs using 4 (WB2) 5/16 x 1-3/8” Wafer Bolts (with at
washer and t-nut), as shown in g. 1.1 and 1.2. Make sure (012) Box Ground is ush to the end of one (010) Box
Leg.
C: Repeat Steps A and B to create a second Box End Assembly so it is
opposite to the rst Box End Assembly. (g. 1.1 and 1.2.)
4 x Box Leg FSC 5/4 x 4 x 16”
2 x Box End FSC 5/4 x 4 x 14-1/4”
2 x Box Ground FSC 5/4 x 4 x 28”
012
011
010
Fig. 1.1
Wood Parts
Step 1: Sand and Water Table Assembly
Part 1
12 x 5/16 x 1-3/8” Wafer Bolt
 (5/16”atwasher,5/16”t-nut)
012
5/16” Flat
Washer
5/16” T-Nut
Notice pilot holes to
outside.
Hardware
011
011
010
Fig. 1.2
Flush
WB2
WB2
012
010
010
WB2
Flush
21 [e-mail]