Installation Guide

Step 35: Attach Access Ladder Rockwall Assembly
Hardware
Pre-drill all holes using a 1/8” drill bit before installing the Wafer Lags
A: Remove (030) Board Access from the Access Ladder Rockwall, previously assembled in Step 3. Set the
board and screws aside, they will be re-attached. (g. 35.2)
B: Place the Access Ladder Rockwall on the Back side of the fort and attach to (064) Back Floor with 1
(WL3) 1/4 x 1-3/8” Wafer Lag Screw (with at washer) in each Swing Bracket. (g. 35.1, 35.2 and 35.3).
C: Re-attach (030) Board Access to the same place it was removed. (g. 35.2)
Fig. 35.3
064
3 x 1/4 x 1-3/8” Wafer Lag
 (1/4”atwasher)
WL3
Fig. 35.1
Fig. 35.2
1/4” Flat
Washer
030
WL3
Important. Flush
to Floor Boards.
Back
064
105 [e-mail]