Installation Guide
Step 31: Attach Swing End Ground Stakes
Other Parts
A: In the 2 places shown in g. 31.1 drive the Rebar Ground Stakes 13” into the ground against the boards. Be
careful not to hit the washer while hammering stakes into the ground as this could cause the washer to break off.
B: Attach ground stakes to (272) SW Posts using 1 (S7) #12 x 2” Pan Screw per ground stake as shown in g. 31.1.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
Warning! Topreventtippingandavoidpotentialinjury,stakesmustbedriven13”into
ground.Diggingordrivingstakescanbedangerousifyoudonotcheckrstforunder-ground
wiring,cablesorgaslines.
Fig. 31.1
2 x #12 x 2” Pan Screw
S7
Hardware
Rebar
Ground
Stake
13” In Ground
2 x Rebar Ground Stake
272
S7
Rebar
Ground
Stake
1 per ground stake
100 support@cedarsummitplay.com