Instructions / Assembly

15 support@cedarsummitplay.com

Fig. 4.2

Fig. 4.1

Step 4: Attach Flange Assembly to Fort

Part 1

Hardware

14 x #12 x 1” Pan Screw

4 x #12 x 2” Pan Screw

8 x #12 Screw Bezel

(5 per side)

A: With a helper place the Flange Assembly ush to the top opening in (2622) End Panel Assembly as shown in

g. 4.1, then pre-drill 1/8” pilot holes in (8935) Lower SL Insert for the 4 bottom mounting locations (approximate

spots where circles are on gure), making sure the pre-drilled holes are a minimum of 1” deep. (g. 4.2)

B: Attach Flange Assembly to (8935) Lower SL Insert using 4 (S7) #12 x 2” Pan Screws (with #12 Screw Bezel)

in the pre-drilled holes. (g. 4.2) Make sure the at surfaces of the Flange Assembly are ush to the (2622) End

Panel Assembly and (2602) Upper Jamb as shown in g. 4.3.

C: Attach the Flange Assembly ush to top of (2622) End Panel Assembly using 4 (S6) #12 x 1” Pan Screws

(with #12 Screw Bezel) and to (2602) Upper Jamb and side of (2622) End Panel Assembly using 5 (S6) #12 x 1”

Pan Screws per side. (g. 4.2)

Flange

Assembly

w/ #12 Screw

Bezel

Top

Bottom of

slide ush with

(8935) Lower

SL Insert

Top of (2622) End

Panel Assembly

opening

Outside View

Inside View

2622

Top

Side