Installation Guide

30 [e-mail]
SCALE:1:50 WEIGHT:
A
SHEET 1 OF 3
SIZE
Details
DWG. NO.
REV.
Attach the hour to the minute hand and then from rear of the Clock
Base, to the Clock Adapter using #6 x 9mm self-tap screw.
Fasten Clock to Clock Blocks using 4- #8 x 1½" Wood Screws
SCALE:1:50 WEIGHT:
A
SHEET 1 OF 3
SIZE
Details
DWG. NO.
REV.
Attach the hour to the minute hand and then from rear of the Clock
Base, to the Clock Adapter using #6 x 9mm self-tap screw.
Fasten Clock to Clock Blocks using 4- #8 x 1½" Wood Screws
SCALE:1:50 WEIGHT:
A
SHEET 1 OF 3
SIZE
Details
DWG. NO.
REV.
Attach the hour to the minute hand and then from rear of the Clock
Base, to the Clock Adapter using #6 x 9mm self-tap screw.
Fasten Clock to Clock Blocks using 4- #8 x 1½" Wood Screws
Step 12: How to Install Inserts - Clock Assembly
There is 1 Clock Set provided with the Main Clubhouse and Swing. Depending on which fort you have purchased
determines where it is installed, see Fort Guide. See below for how to assemble and attach the Clock Set.
When installing you will need the following:
Base Clock, Clock Subset (includes minute and hour hands, clock adapter and clock screw), 2 (2717) Clock Blocks
and 4 x (S20) #8 x 1-3/8” Wood Screws.
To assemble Clock insert the Clock Adapter from the back of the Base Clock, place the Hour Hand over the Clock
Adapter making sure they are lined up properly. Press the Minute Hand over the Hour Hand and connect with
Clock Screw.
Attach assembled Clock through panel and into each (2717) Clock Block with 4 (S20) #8 x 1-3/8” Wood Screws.
Panel
Base Clock
Minute Hand
Hour Hand
Clock
Adapter
2717
2717
Base Clock
Clock
Screw
Inside View
Outside ViewSide View
Do not over tighten screws.
S20