Installation Guide

16 [e-mail]
SCALE:1:50 WEIGHT:
Base 1 -Panel Connect
SHEET 7 OF 9
REV.
A
DWG. NO.
SIZE
Important! Build on flat surface
1 x End Panel Assembly 1-1/4 x 42 x 87”
Wood Parts
2622
Hardware
8 x 1/4 x 2-1/2” Wafer Lag
WL5
Back
Side Wall
2618
Swing Side
Front
Step 2: Frame Assembly
Part 2
B: Place (2622) End Panel Assembly between both (2618) Front Back Panels noticing the panel orientations.
The tops and bottoms of the panels should be ush. Make sure the panels are square then using the pilot
holes as a guide pre-drill with a 3/16” drill bit and fasten the back (2618) Front Back Panel to (2622) End Panel
Assembly and (2622) End Panel Assembly to the front (2618) Front Back Panel with 4 (WL5) 1/4 x 2-1/2” Wafer
Lags per side. (g. 2.4)
WL5
WL5
Fig. 2.4
2622
Notice back (2618)
Front Back Panel
overlaps (2622) End
Panel Assembly
Notice (2622) End
Panel Assembly
overlaps front (2618)
Front Back Panel