Installation Guide

 31  [e-mail]
Step 12: Swing Wall Assembly
Note: Pre-drill all holes using a 1/8” drill bit before installing the Lag Screws.
A:Onthegroundlayonedge2(0945)ShortPoststhenlooselyattach(0948)SWGroundwith4(H4)1/4x4”
HexBolts(withlockwasher,atwasherandt-nut)and(0437)SWFloor(inthebottomholes)with2(H8)1/4x
4-1/4”HexBolts(withlockwasher,atwasherandt-nut)asshowning.12.1.Attach15/16”T-nuttothecentre
holein(0437)SWFloor.Keep bolts loose.
B:Attach1(0956)LowerPostushtothebottomedgeofeach(0945)ShortPostwith5(S4)#8x3”Wood
Screwsperboardasshowning12.2.Attacheach(0369)LowerDiagonalto(0948)SWGroundusing1(H2)
1/4x2”HexBolt.Squaretheassemblythenattach(0369)LowerDiagonaltoeach(0945)ShortPostwith1
(LS3)1/4x3”LagScrew(withatwasher)perboard.(g12.2)
C:Makesureassemblyissquareandthenfasten(0437)FloorEndto(0945)ShortPostswith2(LS3)1/4x3”
LagScrews(withatwasher).(g.12.2)
D: Tightenallbolts.
Notice the hole
locations
Wood Parts
Hardware
2 x Short Post 2 x 4 x 84”
1 x SW Ground 1 x 5 x 78”
1 x SW Floor 5/4 x 6 x 41-1/2”
2 x Lower Post 2 x 3 x 56”
2 x Lower Diagonal 2 x 3 x 37”
0945
0956
0437
0948
Fig. 12.1
1/4”lock
washer
1/4”at
washer
1/4”
t-nut
Fig. 12.2
0945
0945
0948
0437
H8
5/16”
t-nut
0369
0369
0956
0437
0948
LS3
LS3
H2
LS3
S4
1/4”
t-nut
1/4”at
washer
1/4”at
washer
1/4”lock
washer
x5perside
0369
Flush
Flush
4 x 1/4 x 3” Lag Screw
(1/4” at washer)
10 x #8 x 3” Wood Screw
1 x 5/16” t-nut
2 x 1/4 x 4-1/4” Hex Bolt
(1/4” lock washer, 1/4” at washer, 1/4” t-nut)
4 x 1/4 x 4” Hex Bolt
(1/4” lock washer, 1/4” at washer, 1/4” t-nut)
2 x 1/4 x 2” Hex Bolt
(1/4” lock washer, 1/4” at washer, 1/4” t-nut)
H8
H4
H2
S4
1/4”at
washer
LS3
0945
0956
Note: (0956) is
mounted to (0945)
on edge
x2
Notice location of
pilot holes
H4
H2