Installation Guide

 28  [e-mail]
Step 9: Connect Monkey Bar Assemblies
A:UsingaMonkeyBracketconnectboth(1565)MKRailShortstoeach(2580)PostMKwith1(G10)5/16x
3”HexBolt(withlockwasher,atwasherandt-nut)andMonkeyBrackettotherailsusing2(S6)#12x1”Pan
Screwsperrailasshowning.9.1and9.2.Besuretoattachthecorrectend,usingthe1-1/4”measurement
showning.9.2asyourguide.
B:AttachMonkeyBrackettoboth(2580)PostMKswith2(S6)#12x1”PanScrewsperbracket.(g.9.2)
Note: Pre-drill all holes using a 1/8” drill bit before installing the Pan Screws.
Monkey
Bracket
Hardware
2 x 5/16 x 3” Hex Bolt
(5/16” lock washer, 5/16” at washer, 5/16” t-nut)
8 x #12 x 1” Pan Screw
1565
S6
2580
G10
Fig. 9.1
Fig. 9.2
5/16”Flat
Washer
5/16”Lock
Washer
5/16”
T-Nut
S6
G10
G10
x4
Other Parts
2 x Monkey Bracket
2580
S6
1565
1-1/4”