Manualshelf

Installation Guide

ManualsBrandsCedar Summit ManualsOtherBarrington Playset
21222324252627282930
27 support@cedarsummitplay.com
Step 8: Monkey Ladder Assembly
C: Attach(858)1-1/8x18-5/8”Doweltobothpostswith2(S2)#8x1-1/2”WoodScrews.Twoscrewsare
installedfromtopoftherailsandtheothersfromthebottomasshowning.8.3.
D: Atbottomof(2580)PostMKsattach(0353)MKGroundwith2(H12)1/4x3”HexBolts(withlockwasher,
atwasherandt-nut).Be sure to keep the bolts loose.(g.8.3)
E: Makesuretheassemblyissquareandthenattach1(0369)LowerDiagonaltoeachendof(0353)MK
Groundwith1(H2)1/4x2”HexBolt(withlockwasher,atwasherandt-nut),keepingtheboltsloose,andto
each(2580)MKPostwith1(LS2)1/4x2-1/2”LagScrew(withatwasher).Oncelagscrewsareinstalled
tightenallboltsfromStepsD&E.(g.8.3)
Note: Pre-drill all holes using a 1/8” drill bit before installing the Lag Screws and Wood Screws.
A:Insert2(858)1-1/8x18-5/8”Dowelsinto2(2580)PostMKasshowning.8.1.
B:Makesureshoulderofdowelisagainsteachpostbeforepre-drilling
pilotholes.Drill1/8”pilotholesthroughthepostsandintothedowelto
preventsplitting.(g.8.2and8.3)
Wood Parts
Hardware
2 x 1/4 x 3” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
2 x 1/4 x 2” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
2 x 1/4 x 2-1/2” Lag Screw (1/4” at washer)
4 x #8 x 1-1/2” Wood Screw
2 x Lower Diagonal 2 x 3 x 37”
1 x MK Ground 1 x 4 x 55-1/4”
2 x Post MK 2 x 3 x 85-7/16”
2 x Tennon Dowel 1-1/8 x 18-5/8”
0369
S2
0353
2580
858
LS2
H2
H12
0369
0353
LS2
2580
858
H2
LS2
858
2580
Fig. 8.1
Fig. 8.3
1/4”Flat
Washer
1/4”Lock
Washer
1/4”
T-Nut
1/4”Flat
Washer
Fig. 8.2
858
0369
S2
x2per
dowel
Note:Pilotholesat
bottomofthisrail
Note:Pilotholesat
topofthisrail
2580
H12
H2