Installation Guide

 22  [e-mail]
Step 5: Attach Swing End to Swing Beam
A:Place(4919)SWRailBlockinthecentrebetween(1826)FrontBeamand(1825)BackBeamandattachwith
1(H8)1/4x4-1/4”HexBolt(withlockwasher,atwasherandt-nut).(g.5.1and5.2)
B:AttachSwingEndAssemblytothesideoftheSwingBeamAssemblywiththeoverhang(g.5.3and5.4)using
1(G5)5/16x4-1/2”HexBolt(withlockwasher,atwasherandt-nut)inthetopholeofTrianglePlateand1(G8)
5/16x2”HexBolt(with2atwashersandlocknut)inthebottomholeofTrianglePlate.(g.5.3)Makesure
SwingEndAssemblyaresoutatanangle.(g.5.4)
C: Attach2GliderHangerstotheSwingBeamAssemblyusing2(G7)5/16x5-1/2”HexBolts(with2atwashers
andlocknut)perGliderHanger.(g.5.1and5.3)
Wood Parts
Other Parts
1 x SW Rail Block 2 x 4 x 5-3/8”
4919
2 x Glider Hanger
Hardware
1 x 1/4 x 4-1/4” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
1 x 5/16 x 4-1/2” Hex Bolt (5/16” lock washer, 5/16” at washer, 5/16” t-nut)
4 x 5/16 x 5-1/2” Hex Bolt (5/16” at washer x2, 5/16” lock nut)
1 x 5/16 x 2” Hex Bolt (5/16” at washer x2, 5/16” lock nut)
H8
G5
G8
G7
100°
WARNING:
Glider Hangers must be tight
and secure to Swing Beams.
Glider
Hangers
Glider
Hanger
Side with
overhang
Fig. 5.1
Fig. 5.2
Fig. 5.3Fig. 5.4
1/4”Flat
Washer
1/4”Lock
Washer
1/4”
T-Nut
H8
5/16”Flat
Washer
5/16”
LockNut
5/16”Flat
Washer
5/16”Lock
Washer
5/16”
T-Nut
5/16”Flat
Washer
5/16”
LockNut
G8
G7
1826
4919
1825
G5