Installation Guide

 87  support@cedarsummitplay.com

Step 43: Attach Exit End Assembly to Fort

Note: When installing Pan Bolts make sure to

look at holes so bolts go through the side with

the round recess and the lock nuts go through

the side with the hexagonal recess. Keep all bolts

loose until further step.

FittheExitEndAssemblytothelastElbow

Assemblybyliningupthearrowsoneachassembly.

Noticetheelboworientation.(g.43.1)

B: Attach1TNR2SlideClampRingtothetopofthe

joinedAssembliesusing3(PB1)1/4x3/4”PanBolts

(withlocknut),makingsuretomatchthearrowsup

withtheendoftheclampring(whereaseamwillbe)

asshowning.43.1.

Use Quadrex Driver as a guide pin for each hole

before inserting bolt.

Attach1TNR2SlideClampRingtothebottomof

thejoinedAssembliesusing3(PB1)1/4x3/4”Pan

Bolts(withlocknut),makingsuretomatchthearrows

upwiththeendoftheclampring(whereaseamwill

be)asshowning.43.2.

D:Connectthe2TNR2SlideClampRingstogether

in2spotsusing1(PB1)1/4x3/4”PanBolt(withlock

nut)perhole.Makesureseamsandarrowslineup

andthentightenallbolts.(g.43.3).

Hardware

8 x 1/4 x 3/4” Pan Bolt

(1/4” lock nut)

PB1

Other Parts

2 x TNR2 Slide Clamp Ring

Bottom Slide Bolt Holes

After the clamp rings

are attached to the

elbows, fasten them

end to end with two

pan bolts and lock nuts

PB1

Lock

Nut

Make sure arrows

are aligned

Elbow

Assembly