Installation Guide

 83  [e-mail]
Step 39: Attach Elbow Assembly to Elbow Assembly
Part 2
Hardware
5 x 1/4 x 3/4” Pan Bolt
(1/4” lock nut)
PB1
Other Parts
1 x TNR2 Slide Clamp Ring
Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the
round recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose
until further step.
C:
Attach1TNR2SlideClampRingtothebottomofthejoinedAssembliesusing3(PB1)1/4x3/4”PanBolts
(withlocknut),makingsuretomatchthearrowsupwiththeendoftheclampring(whereaseamwillbe)as
showning.39.3and39.4.
D: Connectthe2TNR2SlideClampRingstogetherin2spotsusing1(PB1)1/4x3/4”PanBolt(withlock
nut)perhole.Makesureseamsandarrowslineupandthentightenallbolts.(g.39.3and39.5).
DO NOT USE
USE IMAGE PG 125
DO NOT USE
USE IMAGE PG 125
Elbow
Assembly
Bottom Slide Bolt Holes
After the clamp rings
are attached to the
elbows, fasten them
end to end with two
pan bolts and lock nuts
PB1
Lock
Nut
PB1
Lock
Nut
DO NOT USE
USE IMAGE PG 125
Make sure arrows
are aligned
Elbow
Assembly
Fig. 39.3
Fig. 39.4
Fig. 39.5