Installation Guide

 82  [e-mail]
Step 39: Attach Elbow Assembly to Elbow Assembly
Part 1
Hardware
3 x 1/4 x 3/4” Pan Bolt
(1/4” lock nut)
PB1
Other Parts
1 x TNR2 Slide Clamp Ring
Note: When installing Pan Bolts make sure to look at holes so bolts go
through the side with the round recess and the lock nuts go through
the side with the hexagonal recess. Keep all bolts loose until further
step.
A:
FitasecondElbowAssemblytotherstElbowAssemblybyliningupthe
arrowsoneachassembly.Noticetheelboworientation.(g.39.1)
B: Attach1TNR2SlideClampRingtothetopofthejoinedAssemblies
using3(PB1)1/4x3/4”PanBolts(withlocknut),makingsuretomatchthe
arrowsupwiththeendoftheclampring(whereaseamwillbe)asshownin
g.39.2and39.3.
Use Quadrex Driver as a guide pin for each hole before inserting bolt.
DO NOT USE
USE IMAGE PG 125
Top Slide Bolt Holes
Elbow
Assembly
Make sure
arrows are
aligned
PB1
Lock
Nut
Donotinstallbolt
inClampRingends
untilStep39D
Notice elbow
orientation
Elbow
Assembly
DO NOT USE
USE IMAGE PG 125
Fig. 39.1
Fig. 39.2
Fig. 39.3