Installation Guide

 80  support@cedarsummitplay.com

Step 38: Attach Elbow Assembly to Flange Assembly

Part 1

Note: When installing Pan Bolts make sure to look at holes so bolts go through the side with the

round recess and the lock nuts go through the side with the hexagonal recess. Keep all bolts loose

until further step.

FitoneoftheElbowAssembliestotheFlangeAssemblybyliningupthearrowsoneachassembly.(g.

38.2and38.3)

B: Attach1TNR2SlideClampRingtothetopofthejoinedAssembliesusing3(PB1)1/4x3/4”PanBolts

(withlocknut),makingsuretomatchthearrowsupwiththeendoftheclampring(whereaseamwillbe)as

showning.38.2and38.3.

Use Quadrex Driver as a guide pin for each hole before inserting bolt. (g. 38.3)

Hardware

3 x 1/4 x 3/4” Pan Bolt

(1/4” lock nut)

PB1

Other Parts

1 x Quadrex Driver

1 x TNR2 Slide Clamp Ring

DO NOT USE

USE IMAGE PG 121

QuadrexDriver

Use special driver provided

in locations where the curve

of the elbow are difcult to

reach with a standard driver.

Align each elbow using the

molded arrows with the seam

of the clamp ring.

Donotinstallbolt

inClampRingends

untilStep38D