Installation Guide

 66  [e-mail]
Step 30: Attach Swing Assembly to Fort
Hardware
1 x 5/16 x 4-1/2” Hex Bolt (5/16” lock washer, 5/16” at washer, 5/16” t-nut)
1 x 5/16 x 2” Hex Bolt (5/16” at washer x 2, 5/16” lock nut)
4 x #8 x 2-1/2” Wood Screw
Fig. 30.2
G5
A:AttachSwingAssemblyfromStep6to(2025)WallMountwith1(G5)5/16x4-1/2”HexBolt(withlock
washer,atwasherandt-nut)and1(G8)5/16x2”HexBolt(with2atwashersand1locknut)asshowning.
30.1and30.2.
B:Drive1(0318)GroundStake10-1/2”intothegroundateach(1863)SWPostandattachwith2(S3)#8x
2-1/2”WoodScrewspergroundstake.(g.30.1and30.3)
G8
G5
Fig. 30.1
5/16”Lock
Washer
5/16”Flat
Washer
5/16”
T-Nut
5/16”
Locknut
5/16”Flat
Washer
1863
WARNING: To prevent tipping and
avoid potential injury, stakes must be
driven 10-1/2” into ground. Digging or
driving stakes can be dangerous if you
do not check rst for underground wiring,
cables or gas lines.
Fig. 30.3
0318
S3
G8
10-1/2”
IntoGround
2025
Wood Parts
2 x Ground Stake 1-1/4 x 1-1/2 x 14”
0318
S3