Installation Guide

 34  [e-mail]
Step 10: Swing Wall Assembly
Part 2
Note: Pre-drill all holes using a 1/8” drill bit before installing the Lag Screws.
D:
Makesuretheassemblyissquareandthenattach(0437)SWFloortoboth(1400)Postsinthetopholesusing
2(LS3)1/4x3”LagScrews(withatwasher)and(2598)GroundSWSidetoeach(1401)LowerPostwith2(H4)
1/4x4””HexBolt(withlockwasher,atwasherandt-nut).(g.10.2)
E:Attach1(2491)Diagonaltooneendof(2598)GroundSWSideusing1(H2)1/4x2”HexBolt(withlock
washer,atwasherandt-nut)asshowning.10.2.
F: Attach1(0403)Gussettoeach(1401)LowerPostandtobottomof(0437)SWFloorwith2(LS3)1/4x3”Lag
Screws(withatwasher)pergusset.(g.10.2)
G: TightenalltheboltsintheSwingWallAssemblyexceptfortheboltsin(2025)WallMount.
2 x Gusset 5/4 x 4 x 18-1/2”
1 x Diagonal 2 x 3 x 42-1/4”
Hardware
Wood Parts
1 x 1/4 x 2” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
6 x 1/4 x 3” Lag Screw (1/4” at washer)
2 x 1/4 x 4” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
H2
H2
LS3
0403
2491
LS3
Fig. 10.2
1/4”Flat
Washer
1/4”Lock
Washer
1/4”
T-Nut
2598
LS3
LS3
1401
1401
1/4”Flat
Washer
0437
2491
0403
0403
2025
H4
H4