Product specifications

Attaching to Wall Anchor Method

For attaching mounting bracket to hollow walls (wall areas

between studs) or solid walls (concrete or masonry):

1. Drill holes at marked locations using 5/16-inch drill bit.

For solid walls (concrete or masonry), drill at least 1

inch deep.

2. Fold wall anchor as shown in Fig. 7.

3. Insert wall anchor (wings rst) into hole. Tap anchor

ush to wall.

4. For thin walls (1/2 inch or less), insert white key into

wall anchor. Push white key to “pop” open anchor wings

(see Fig. 8).

IMPORTANT: Do not hammer anchor key! For thick

walls (over 1/2 inch thick) or solid walls, do not pop

open wings.

5. Place mounting bracket onto wall. Line up last hole on

each end of bracket with wall anchors.

6. Insert mounting screws through bracket and into wall

anchors.

7. Tighten screws until mounting bracket is rmly fastened

to wall.

Placing Heater On Mounting Bracket

1. Locate two horizontal slots on back panel of heater (see

Fig. 9).

2. Place heater onto mounting bracket. Slide horizontal

slots onto stand-out tabs on mounting bracket.

Fig. 7 - Folding Anchor

Fig. 8 - Popping Open Anchor

Wing For Thin Walls

Fig. 9 - Mounting Heater

Onto Mounting Bracket

Horizontal Slots