Installation Instructions

5. When you reach the top panel, cut the corner piece to

length and nail it with a color matched nish nail. Leave

1/4" between the top corner piece and the cornice

receiver. If a course of siding ends at an outside corner

that has a Mitered Offset Cornerpost installed, you will

have to cut the Cedar Impressions panel to t.

6. Measure from the edge of the last installed panel to the

edge of the Cornerpost.

7. Add 1-1/2" to this dimension and cut the panel to length.

8. Angle the panel into the Cornerpost and slide it to the

left.

9. Then, slide the panel to the right until the correct

temperature marks line up.

10. Fasten the panel to the wall.

Similar to the top course under a soft or window, cut

shingles to appropriate angle, pre-drill and fasten using

at least two staples or nails. Apply a trim board over the

shingles to conceal the fasteners.

If you have any questions about installing these

products, please call us at 800-233-8990.

Estimating: Refer to CertainTeed Vinyl and Polymer

Siding Installation Guide, Section 5.

Transporting & Storage: Refer to CertainTeed Vinyl and

Polymer Siding Installation Guide, Section 4.

Maintenance: Refer to CertainTeed Vinyl and Polymer

Siding Installation Guide, Section 13.

FPO

cornice cap

1/4" from the edge

ROOFING • SIDING • TRIM • DECKING • RAILING • FENCE

GYPSUM • CEILINGS • INSULATION

ASK ABOUT OUR OTHER CERTAINTEED® PRODUCTS AND SYSTEMS:

Professional: 800-233-8990 Consumer: 800-782-8777

CertainTeed Corporation

20 Moores Road

Malvern, PA 19355