Installation Instructions

Installing Under a
Window or Opening
Install undersill trim. Cut
the panel to t under
the window. Drill a 3/16"
hole in the center of the
nail hem. Using a snap
lock punch, raise tab
faces on the outside of
the panel 1/4" from the
trimmed edge, 6" apart.
Lock the panel into the previous course, and center nail
the siding through the 3/16" hole drilled earlier. (Center
nailing controls the direction of the panel’s expansion and
contraction.) Lock the panel into place (gure 8).
Installing Over a Window or Opening
Cut the panel to t over the window by measuring from
the locking tab of the previous row to the bottom of the
receiving pocket (gure 9). Add 1/8" to this measurement.
Turn the panel over and, using this measurement,
measure from the bottom of the return leg (gure 10).
Cut the panel to this dimension. Install the cut panel
by positioning the panel over the window and into the
receiving pocket. Lock the cut panel into the previous
course by pushing in and up. The cut edge should be 1/4"
below the top of the receiving pocket.
Finishing the Top
Course
To nish the top course
of siding, attach cornice
receiver to the top of
the wall under the eave
or soft. Trim the top
panel to within 1/4" of
the cornice receiver. Using a nail slot punch, punch nail
slots 1/4" from the trimmed edge, 16" apart. Nail off the
top course and snap the cornice molding into the cornice
receiver (gure 11).
Installing Mitered Offset
Cornerpost
Before applying siding and
accessories, make certain
the substrate is watertight.
To be properly protected
from precipitation, make
sure you have properly
ashed the substrate so
that it sheds water outside
the siding. The siding and accessories alone are not
meant to be a watertight barrier.
For the best appearance and easier installation, we
suggest you install the Mitered Offset Cornerpost as you
move up the wall. If you prefer, you can install Mitered
Offset Cornerposts after the siding has been installed.
1. Remove nail hem from cornerpost as shown in gure 12
and use as your starter. Install fastener through each
nail hole. Note: save the corner that was cut for nishing
nal course.
2. Install the rst Cedar Impressions panel 2-3/4" from the
edge of the outside wall (gure 13).
3. Once the panel has been fastened, hook the corner
piece over the siding, making sure the corner piece is
locked into the nail hem starter (gure 14).
4. Nail through the top two slots of the cornerpost.
5. Continue installing the corner pieces as you move up
the wall (gure 15).
window
Cedar Impressions
undersill trim
Cedar Impressions
panel
measure from
the locking tab
to the bottom
of the receiving
channel and add
1/8"
bottom of
receiving channel
back side of
panel to be cut
bottom of
return leg
FPO
cornice receiver
cornice
molding
Cedar Impressions panel
1/4"
1/4"
gure 8
gure 12
gure 9
gure 10
gure 11
gure 15
gure 13
2-3/4"
from
edge
remove and
use as
starter
gure 14