Installation Instructions

CertainTeed

Code No. CTS507

ROOFING • SIDING • TRIM • DECKING • RAILING • FENCE

GYPSUM • CEILINGS • INSULATION

www.certainteed.com http://blog.certainteed.com

ASK ABOUT OUR OTHER CERTAINTEED

PRODUCTS AND SYSTEMS:

CertainTeed Corporation

20 Moores Road

Malvern, PA 19355

Professional: 800-233-8990

Consumer: 800-782-8777

6. When you reach the top panel, use the cornerpost that

was cut previously to create the starter course and cut

this piece to length and nail it with a color matched

nish nail. Measure from lowest butt edge of the last

panel installed to the cornice receiver. Subtract 1/4"

from measurement and cut your corner to that length.

Leave 1/4" between the top corner piece and the cornice

receiver.

If you nish the top course of Cedar Impressions siding

with cornice molding, you should also install Vinyl

Carpentry Cornice Cap. Cornice Cap covers the gap

between the two pieces of cornice molding and seamlessly

nishes the installation of the Mitered Cornerpost.

If you have any questions about installing these

products, please call us at 800-233-8990.

Estimating: Refer to CertainTeed Vinyl and Polymer

Siding Installation Guide, Section 5.

Transporting & Storage: Refer to CertainTeed Vinyl and

Polymer Siding Installation Guide, Section 4.

Maintenance: Refer to CertainTeed Vinyl and Polymer

Siding Installation Guide, Section 13.

cornice cap

1/4" from the edge