Instructions / Assembly

ManualsBrandsCedar Hill ManualsLighting11 in. LED Wall Lights, Waterproof 25-Watt Cylinder Up and Down Wall Lights for Yard Garage

702 Interchange Blvd, Newark DE, 19711, USA

Pre Installation

PLANNING INSTALLATION

□ Read all instructions before installation.

□ To avoid damaging this product, assemble it on a soft, non abrasive surface, such as carpet or cardboard.

□ Keep your receipt and these instructions for proof of purchase.

Safety Information

□ Consult a qualified electrician if you have any

electrical questions.

CAUTION:

WARNING:

Outdoor Wall Lamp

USE AND CARE GUIDE

Model#: 107402

Safety

glasses

Electrical

tape

Phillips

screwdriver

Flat blade

screwdriver

Pliers

Wire

strippers

702 Interchange Blvd, Newark DE, 19711, USA

Pre-installation (continued)

PACKAGE CONTENTS

Part Description Quantity

A Fixture body 1

HARDWARE INCLUDED

NOTE: Hardware not shown to actual size.

Part Description Quantity

AA Mounting Bracket 1

BB Mounting Screw 2

CC Wire Nut 3

TOOLS REQUIRED

Ladder

702 Interchange Blvd, Newark DE, 19711, USA

Installation

Making the electrical connections

TURNING THE LIGHT ON

Securing the light fixture

□ Connect the copper wire from the fixture body (A) to the

mounting bracket (AA) by securing it with the pre-installed

ground screw.

□ Connect the black wire from the fixture to the black wire from

the outlet box, the white wire from the fixture to the white wire

from the outlet box, and the copper wire from the fixture to the

ground wire from the outlet box with thewire nuts (CC).

Secure with electrical tape (not included).

□ After wires are connected, tuck them carefully inside the

junction box.

Attaching the mounting unit to the

junction box.

□ Remove the two pre-assembled screws and

washers from the mounting bracket (AA).

□ Screw the mounting screws (BB) through the

holes on the mounting bracket (AA) into the

screw holes on the outlet box.

□ Put the fixture body (A) over the mounting bracket (AA).

□ Secure the light fixture with two previously-removed screws

and washers.

NOTE: If the wires from the fixture are the same color,

attach the side with markings or letters to the black

(positive) wire and the other to the white (neutral) wire.

NOTE: To avoid any waterpro g problems, please

make sure the lig xture s the mounting surface

perfectly during installation and use waterproof glue

around the canopy for better sealing after installation.

702 Interchange Blvd, Newark DE, 19711, USA

Operation

□

Turn the light switch on to activate the fixture.

Care and Cleaning

□ Clean the lamp with a soft, dry cloth.

□ Do not use any cleaners with chemicals, solvents, or harsh abrasives.

Troubleshooting

Problem Possible Cause Solution

The power is off. Ensure the power supply is On.

There is a faulty wire connection. Check the wiring.

The circuit breaker is off.

Ensure the circuit breaker is in the On

position.

The fuse blows or circuit breaker

trips when the light is turned on.

There are crossed wires or the

power wire is grounding out.

Check the wire connections.

the Customer Service Team.

ontact a qualifed electrician or contact

The bulb will not light.

Inspect the wire insulation for any cuts,

abrasions, or exposed copper that may have resulted during

shipping. If there is a defect in the wire, do not attempt

installation. Please contact our Customer Service Team.

Before starting installation of this fixuture

or removal of a previous fixtu re, disconnect the power

by turning off the circuit breaker or by removing the

fuse at the fuse box.

___________BB ___________CC

___________AA