Installation Instructions
23
ANY  NONCONFORMITY  IN  THE  PRODUCT(S).  In  the  event  of 
any  Nonconformity  covered  by  this  or  any  implied  warranty  not 
disclaimed in Section 4, Manufacturer will, at its sole option and at 
its expense, either repair or replace defective or damaged Product(s) 
including  all  labor  and  materials  necessary  to  perform  the  work. 
MANUFACTURER  MAY  DISCONTINUE,  MODIFY  OR  CHANGE 
THE  COLOR  OF  ANY  PRODUCT(S)  WITHOUT  NOTICE  AND 
SHALL BEAR NO LIABILITY FOR ANY SUCH COLOR CHANGE. IF 
MANUFACTURER  AGREES  TO  REPLACE  PRODUCT(S)  UNDER 
THIS  WARRANTY  AND  AN  EXACT  REPLACEMENT  PRODUCT 
IS  NOT  AVAILABLE,  MANUFACTURER  MAY  SUBSTITUTE 
ANOTHER  PRODUCT  IT  DEEMS  TO  BE  EQUIVALENT  IN  VALUE 
AND QUALITY.
Any dispute concerning this warranty shall be submitted to binding 
arbitration  to  a  mutually  agreed  arbitrator;  or,  if  the  parties  fail  to 
agree, to the American Arbitration Association to be resolved using 
its  Commercial  Arbitration  Rules.  The  jurisdiction  of  the  arbitrator 
over the dispute shall be exclusive and the decision of the arbitrator 
shall be binding on the parties and non-appealable.
6. Exclusion of Other Remedies
IN  NO  EVENT  SHALL  MANUFACTURER  BE  LIABLE  TO  ANY 
PERSON FOR AN AMOUNT GREATER THAN THE VALUE OF THE 
REPAIR  OR  REPLACEMENT  OF  THE  PRODUCT.  IN  NO  EVENT 
WILL  THE  MANUFACTURER  BE  LIABLE  FOR  ANY  INCIDENTAL, 
SPECIAL, INDIRECT, MULTIPLE, PUNITIVE OR CONSEQUENTIAL 
DAMAGES RESULTING FROM ANY DEFECT IN THE PRODUCT(S) 
SUPPLIED,  INCLUDING,  BUT  NOT  LIMITED  TO  DAMAGE  TO 
PROPERTY OR LOST PROFITS REGARDLESS OF WHETHER SUCH 
CLAIMS ARE BASED ON THEORIES OF CONTRACT, WARRANTY, 
TORT  (INCLUDING  NEGLIGENCE  AND  GROSS  NEGLIGENCE), 
STRICT LIABILITY, STATUTORY LIABILITY OR OTHERWISE.
Some states and provinces do not allow the exclusion or limitation 
of incidental or consequential damages, so the  above limitation or 
exclusion may not apply to you.
7. Responsibility of Purchaser/ Owner. COMPLIANCE WITH EACH 
OF THE ITEMS SET OUT BELOW IN SECTIONS A and B INCLUSIVE 
IS  A  CONDITION  TO  MANUFACTURER’S  OBLIGATIONS  UNDER 
THIS WARRANTY AND THE FAILURE TO COMPLY WITH ANY ONE 
OR MORE OF THE ITEMS SHALL VOID ANY RIGHTS OWNER AND 
PURCHASER MAY HAVE AGAINST MANUFACTURER.
A. Warranty Registration/Claims
(i)  A  warranty  registration  card  must  be  properly  completed 
and  mailed  to  Manufacturer  within  30  days  after  the  Product(s) 
installation date . A card is attached for convenience.
(ii) All claims under this Warranty must be sent in writing within 45 
days  after  the  discovery  of  the  defect,  and  before  beginning  any 
permanent repair, to Manufacturer at 402 Boyer Circle, Williston VT  
05495, Attention: TimberCrest Quality Assurance Manager.
B. Other
(i) Owner must notify Manufacturer of any change in ownership of 
the home  on  which  the  Product)s)  are installed within  90  days  of 
the transfer of title.
(ii)  IT  IS  THE  OWNER’S  RESPONSIBILITY  TO  ESTABLISH  THE 
DATE  OF  INSTALLATION.  The  Owner  should  do  this  by  retaining 
any  records  which  would  tend  to  prove  when  the  Product(s)  was 
installed, including but not limited to: purchase invoices and receipts, 
contractor’s billings, service contracts, and building permits.
(iii) Upon reasonable notice, the Owner must allow MANUFACTURER’s 
agents to enter the property and building on which the Product(s) is 
installed to inspect such Product(s).
This Warranty gives you specific legal rights, and you may also have 
other rights which vary from state to state.
For further information, contact:
KP Building Products TimberCrest Quality Assurance Manager
402 Boyer Circle, Williston VT  05495 
800-845-6541
TimberCrest i/s a trademark of KP Building Products.
©2006 KP Building Products. All rights reserved.










