Instruction Manual

ROCKSTAR 900 ULTIMATE ERGOWETROCKSTAR 900 ULTIMATE ERGOWET 4140
Take one end of the brush out as shown on the image. After washing and drying all the parts,
assemble it back in order to use the brush again.
Fig. 23 (Page 50)
Removing the battery
Press the battery release button and take the battery out as shown on the image. Store the
battery in a plastic bag and leave it in a dry place.
Fig. 24 (Page 51)
Storing the device
If the robot is not going to be used for a long time, remove the battery from the product and
store it in a dry and safe place.
Dirt sensors
When the device does not detect dirt or dust, or detects very little, the screen will display a
full circle when turned on. In this case, wipe the dirt sensors with a soft, dry cloth.
Fig. 25. (Page 51)
6. WET ACCESSORY FOR SCRUBBING
When the vacuum cleaner is not going to be used for a long time, please remove the
water tank and empty the remaining water. Do not expose it to direct sunlight or to damp
environments.
Mop installation/removal
Removing/installing the water tank
Fig. 25 (Page 51)
In order to install/remove the cleaning cloth you must rst disassemble the water tank from
the rest of the appliance. In order to remove the water tank, use your foot to hold it against
the ground and pull upward until it unclicks from position.
Once the cloth has been installed and the water tank has been lled, to reinstall the water
tank, simply push it back together until it clicks into position.
Note: Do not use cleaning agents. Use clean and room temperature water only. Do not use
the vacuum cleaner to vacuum water.
Installing the mop cloth
Place the mop cloth on the ground with the Velcro facing upwards. Align the mop cloth with
the Velcro strips on the water tank and attach it.
Fig. 26 (Page 51)
Motorised brush for upholstery.
Removes dust mites and bacteria from beds and sofas.
Fig. 17 (Page 48)
Union elbow
Suitable for cleaning dust from high wardrobes, roofs, windows, corners, etc.
Fig. 18 (Page 48)
Special brush for fabrics
Adjustable accessory to remove all types of dust trapped in fabrics.
Installation of accessories
Fig. 19 (Page 48)
Fig. 19.1 (Page 49)
5. CLEANING AND MAINTENANCE
Disconnect the appliance from the power supply and allow it to cool down before cleaning.
Use a soft, damp cloth to clean the device’s surface.
Do not immerse the appliance in water or other liquid.
Do not use abrasive cleaners or scouring pads to clean the product.
It is recommended to clean the dust tank after every use. If the device clogs due to built-up
excessive dust, clean it or replace it.
After the brush has been used for a long time, bristles might start to tangle with hair and
other particles. Clean it in order for it to operate correctly again.
Cleaning the dust tank and the filters (Page 50)
Fig. 20
Fig. 21
Fig. 22
Open the dust tank bottom cover unlock button and empty the dust inside.
Hold the device from the handle and pull from it upward to separate de device from the dust
tank.
Turn the lter as shown on the image and disassemble the lter.
After washing and drying all the parts, assemble it back in order to use it again.
Cleaning the Jalisco brush and the Best Friend Care brush
Move the rotary brush release button with the nger toward the arrow and remove the cover
of one of the ends of the brush.
ENGLISH ENGLISH