Instruction Manual

ROCKSTAR 900 ULTIMATE ERGOWETROCKSTAR 900 ULTIMATE ERGOWET 3736
3. PRODUCT ASSEMBLY
Vacuuming tube and suction base assembly
To install the suction base into the vacuuming tube, align both of them making sure the tab on
the suction base matches the guides on the tube, and introduce one into the other until they
are rmly xed. To disassemble them, press the suction base release button and pull from
the vacuuming tube while you hold the suction base.
Warning: When assembling these 2 parts, make sure the handle and the brush are facing the
same direction.
Use the Flex tube to reach and vacuum dirt from the most inaccessible zones. Press the Flex
button to bend the tube.
Fig. 2/2.1/2.2 (Page 35, 46)
Battery assembly
Introduce the battery in the slot located in the handheld vacuum cleaner. Once it is
introduced, it will click into place. Move it slightly to ensure it is properly assembled in place.
Note: Take the battery out and store it in a safe, dry place if the device is not going to be used
in a long period of time.
Fig. 3 (Page 46)
Following the below illustration, keep the vacuuming tube vertically, align the tab on the
vacuuming tube with the guides in the handheld vacuum cleaner and introduce the tube.
Dust tank and handheld vacuum cleaner assembly
To assemble the dust tank to the handheld vacuum cleaner, rst separate the handheld
vacuum cleaner from the vacuuming tube.
Then, press the vacuuming tube release button with one hand and, holding from the handle
with the other one, turn the dust tank anticlockwise to the unlock position indicated on the
dust tank edge.
Fig. 4 (Page 46)
4. OPERATION
Wall charging base installation
First, x the charging base to the wall. To do so, we recommend you place a protective lm
(not included) on the wall’s surface. Then, put the charging base on the wall and make 3
corresponding to the holes to be drilled in order to x the base. Take into account the height
of the installation, it is important that suction base rests on the oor to avoid the charging
base from holding all the vacuum cleaner’s weight. Make 3 holes on the wall and x the
charging base with the supplied M4 x 32 nuts and screws.
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1 (Page 35)
1. Suction base
2. Floor brush release button
3. Vacuuming tube release button
4. Dust tank bottom cover unlock button
5. Dust tank emptying button
6. Speed-control dial
7. Display
8. On/o button
9. Power adapter
10. Fast charge base
11. Includes a 2-in-1 narrow accessory for corners and furniture
12. Includes a wide 2-in-1 accessory for corners and furniture
13. Motorised brush for upholstery.
14. Union elbow
15. Long brush
16. Flexible hose
17. Flex vacuuming tube
18. Jalisco brush
19. Best Friend Care special brush for pet hair
20. Special brush for fabrics
21. Wet scrubbing accessory with mop
22. Flex button
Fig. 1.1 (Page 35)
1. Display
2. Speed-control dial
3. On/o push button
2. BEFORE USE
Take the product out of the box.
Check for any visible damage. If any is observed, contact as soon as possible the Technical
Support Service of Cecotec for advice or reparation.
Fully charge the device before the rst use.
During the rst 3 uses, it is recommended to charge the device for 12 hours between uses.
Once the battery has been charged and used, it will start charging normally.
The normal charge time is 2 hours approx. When the battery is fully charged, unplug it.
ENGLISH