Operator`s manual

GIANT UL BLACK
5
ENGLISH
is advisable to install the restrictor cap on the faucet outlet
in order to reduce the drink outflow (see figure 7).
figure 7
5. 3 CLEANING AND SANITIZING
PROCEDURES
1 - Cleaning and sanitizing of the dispenser are
recommended to guarantee the conservation of the best
product taste and the highest unit efficiency. This section
is a procedural guideline only and is subject to the
requirements of the local Health Authorities.
2 - Prior to the disassembly and cleaning, the machine must
be emptied of product. To do this proceed as follows:
- set the power switch to I position
- set mixer/refrigeration switch(es) to I position (Soft Drink
mode)
- place a pail under each faucet and drain all product from
bowls
- set all control switches to the 0 position
5. 3. 1 DISASSEMBLY
1 - Remove cover from the bowl.
2 - Remove the bowl by lifting its faucet side up and off the
fastening hooks (see figure 8) and slide it out (see figure
9).
figure 8
figure 9
3 - Slide the outer spiral out (see figure 10) and then the
inside auger (see figure 11).
figure 10
figure 11
4 - Remove the bowl gasket from its seat (see figure 12).
figure 12
5 - Remove the faucet assembly sliding the pin and pulling up
the handle. (see figure 13).
figure 13
ATTENTION
Before any disassembly and/or cleaning procedure
make sure that the dispenser is disconnected from its
power source by unplugging it or switching off the 2-
pole wall breaker.