Specifications

ACI/Frangkiser Hutchens Architects 4-07058
Liberty "North" Second High School
Liberty Public School District #53
Building Construction Bid Set
FOOD SERVICE EQUIPMENT 11400-88
wash arms with 14‖ (356mm) wash area ; Slotted, concave wash
nozzles and captivated end caps; minimum 14" separation between
wash and final rinse arms; synchronized rack rail pawl bar
system; side drive system; front-sloping tanks bottoms; fully
automatic operation including auto-fill and auto-start;
separate compartment actuator switches to ensure wash,
recirculating rinse and final rinse are energized only when a
rack is in place; external, easily operable, lever-operated
drain system; low level heater protection; wash pump motors are
self-draining, internal and vertically installed; stainless
steel pump housing and impeller; electro mechanical controls
with a 24 VAC control circuit; single point electrical
connection; easily removable wash arm recirculating rinse arm
block manifold systems, final rinse arms, easily opened large
front access doors remain open without latches; large, removable
stainless pan strainers; built-in pressure regulator; single
point drain connection. Provide with the following options;
1. Right to Left operation
2. Tall hood option to increase vertical clearance from 1‘
6‖(457mm) to 2‘ 2‖.
3. External vent fan control.
4. (2) Vent cowl collar(s) with adjustable damper - 4‖ W x 16‖
Dx 7‖ H (102x406x178mm). One at each end.
B. Furnish and install with dishwasher, from the vent cowls, One
(1) at each end 20 ga. 4" x 16" stainless steel duct and extend
to 3" above finish ceiling, with 1" stainless steel perimeter
trim at ceiling.
C. Provide Traex Rack-Master (4) way indexed dishwasher racks; open
bottoms & sidewalls; handles on all four sides; co-polymer beige
plastic with double wall construction; snap fit extenders.
Provide the following models;
1. Four (4) model TR-1, full size pot / pan / glass ware rack,
3-1/4" inside height, flat open bottom.
2. Four (4) model TR-2, full size flatware rack, 3-1/4" inside
height, open bottom with mesh design.
3. Eight (8) model TR-3, full size peg rack for plates & trays,
3-1/4" inside height.
ITEM NO. F6 - DISH TABLE; CLEAN