Specifications

ACI/Frangkiser Hutchens Architects 4-07058
Liberty "North" Second High School
Liberty Public School District #53
Building Construction Bid Set
FOOD SERVICE EQUIPMENT 11400-28
a. Provide Stainless Steel enclosure panels and fillers where
gaps or spaces occur at equipment tops and bodies, due to
interferences or irregularities in building walls,
columns, outlets, pipes, etc. and above equipment to
ceiling as shown and detailed on drawings. Panels and
fillers shall be attached, having all attaching devices
concealed, unless food service equipment provider has
received approval, in writing, for other means of
attaching.
22. Exhaust Ducts:
a. Construct exhaust ducts of 20 ga. Stainless Steel, unless
otherwise specified. All seams shall be air and water
tight. Ducts shall join equipment or each other, in first
class manner and be air and water tight at these points.
Inside laps of vertical ducts shall project in direction
against air flow.
23. Plastic Laminate Panels / Cabinetry:
a. Materials;
1) High Pressure Plastic Laminate: NEMA LD-3; horizontal
exterior laminates shall have GP-50 (0.05" nominal);
vertical exterior laminates shall be VS-30 (0.03"
nominal); interior surfaces shall be white 4 mil
polyester; concealed surfaces shall receive a high
pressure balancing sheet. Laminate shall be used in
maximum possible sizes to eliminate joints where ever
possible. Joints when necessary shall be hairline.
Plastic laminate, suede finish, standard color as
manufactured by Formica or Wilsonart. Plastic laminate
color to be selected by the Architect.
2) Edge Banding; Provide 3MM Edge Banding on edges of
laminate covered panels. Polyvinyl chloride
impact/chip/mar-resistant edge, machine applied with
hot melt glue. Contact cement not acceptable. Able to
be radiused to 12mm; color to match laminate face.
3) Laminate substrate shall be 3/4" , 49 lb. density
particle board. All face surfaces of particle board
covered with Plastic Laminate. Edges covered with 3MM
edge banding.