Specifications

ACI/Frangkiser Hutchens Architects 4-07058
Liberty "North" Second High School
Liberty Public School District #53
Building Construction Bid Set
FOOD SERVICE EQUIPMENT 11400-24
channel style pull at drawer face top (pull as
detailed).
2) Thermoplastic Drawer Pans; Provide heavy duty
thermoplastic drawer pans with full 1/4" flanges; coved
corners; smooth interior - stipple exterior. Provide
Component Hardware model S80-2020, nominal 20" x 20" x
5"H. unless noted otherwise. Component Hardware model
S80-1520, 15" x 20" x 5"H pans when specifically
specified.
3) Drawer Slides; Component Hardware Group model S52 easily
removable, heavy duty, full extension drawer slides with
Stainless Steel ball bearing wheels, 14 ga. 300 S/S
rails, removable positive stops, 200 lbs. rating.
Installed to be self closing.
b. Drawers shall operate easily without binding on removable
Drawer Slides. Drawer pans shall be easily removable.
Install drawers to be self closing. Drawers, single
under top hung and (3) tier shall be enclosed on back, both
sides and bottom by 18 gauge stainless steel housing (ref.
Enclosed Cabinet Base standard). Cabinet and other
enclosures around drawers shall be verminproof.
14. Rolled Rim Sinks:
a. All metals; shall be Stainless Steel.
b. Sink shall be 14 gauge with all bowl vertical and horizontal
corners coved on 1" R. No solder or caulked fillets
allowed. Sink bowl bottom creased/sloped to drain to
provide complete drainage of sink. At drain valve location,
sink bottom ferruled downward to allow installed drain
valve grate to set flush to or below plane of sink bottom.
14 ga. S/S ―L‖ bracket stud bolted to bottom of sink bowl
to support drain twist action handle. All exposed edges
shall have continuous formed 2"H. Raised Box Edge as
detailed, terminating at back splash and fully welded
thereto (unless specified otherwise). Exposed corners of
Box Edge shall be square. Provide integral back splash
being 10" high (from top of box rim), turned back 2" with
upward 45
o
slope and then straight down 1/2"(unless
specified otherwise). Punch splash face for trim as
specified. Faucets centered over partitions if
multi-compartment sink. Sound deaden bottom of sink.
c. Construct base per Open Frame Base specification of